Cart

Quick Links

All Connectors

Connectors for all system sensors & hardwareEPA, CARB & Emissions Disclaimer- All ECU's are for race purposes only. It's your responsibility to remain in compliance with all federal, state, provincial, or other laws that apply to you.

Showing 17–32 of 64 results

  • smart coil pigtail for IGN-1A

    Pigtail Connector for IGN1A and GM MAF Sensors

     $15.99

    4' Flying lead smart coil pigtail for IGN-1A coils.  The extra length makes these easy to bundle up into a single ignition control harness without needing splices near the coil. Power and primary ground wires are 18 gauge to better handle these coils' p...

    Add to cart
  • Crimp Connector for IGN-1A

    Crimp Connector for IGN-1A

    5 out of 5
    $5.79

    Connector for IGN-1A coils, includes crimp on terminals/pins. Like all of our 'ready to crimp' connectors- we include an extra terminal/pin, just in case.  Click here to see other ignition system components for your project!  

    Add to cart
  • GM Boost Control Connector with Crimp-On Pins

    GM Boost Control Solenoid Connector with Crimp-On Pins

     $11.00

    Weatherpack style connector for GM boost control solenoid. This connector comes with crimp-on pins to keep the number of splices in your wiring harness to a minimum. Note: This connector is not needed for our newer style (12/2008 and newer) non-GM EBC ...

    Add to cart

  • 460 Piece Weather Pack Kit

     $100.00

    Our 460 Piece Weather Pack kits contains everything you need to get your project done right!  We've used other connector kits available on the market in projects around the shop, they never quite met our expectations to be honest.  So in typical DIYAuto...

    Add to cart

  • 755 Piece Weather Pack Kit

    5 out of 5
    $145.00

    Our Weather Pack kits contains everything you need to get your project done right!  We've used other connector kits available on the market in projects around the shop and they never quite met our expectations.  So in typical DIYAutoTune style, we stepp...

    Add to cart
  • GM Boost Control Connector with 6" Pigtail

    GM Boost Control Connector with 6″ Pigtail

     $13.00

    Sealed connector for GM boost control solenoid. This connector is pre-crimped with a 6" pigtail. Note: This connector is not needed for our newer style (12/2008 and newer) non-GM EBC Solenoid. We continue to offer these connectors for customers that ne...

    Add to cart
  • Weather Pack 22 Position Bulkhead Connector Kit

    Weather Pack Bulkhead Connector Kit

    5 out of 5
    $32.00

    Use this giant 22 Position Weather Pack connector to run wires through a firewall or as a quick disconnect for your engine harness, or other components that need a lot of wires. Includes: (1) 22 position male and female connector (13) 20-18 gauge m...

    Add to cart

  • Weather Pack 12 Gauge Terminal Pack – 30 Terminal Sets

     $13.49

    Run out of terminals for your Weather Pack kits (or bought a kit elsewhere that didn't have enough)? We have the pins and seals on their own, without any housings or other parts. This package contains 30 pairs of male and female Weather Pack terminals, pl...

    Add to cart

  • Weather Pack 3 Position, 16-14 Gauge (3) Pack

    5 out of 5
    $8.49

    (3) 3 position weather pack sets including: (3) male and female connectors, (10) male and female 16-14 gauge pins, and (20) 16-14 gauge seals

    Add to cart
  • Weather Pack 3 Position, 20-18 Gauge (3) Pack

    Weather Pack 3 Position, 20-18 Gauge (3) Pack

    5 out of 5
    $8.49

    (3) 3 position weather pack sets including: (3) male and female connectors, (10) male and female 20-18 gauge pins, and (20) 20-18 gauge seals

    Add to cart
  • DB37 Solder Cup Connector for MS3X

    DB37 Solder Cup Connector for MS3X

     $6.50

    To make sure you can't accidentally switch the upper and lower harnesses, the MS3X harness uses a male DB37 connector instead of a female one.  We've packaged a DB37 male solder cup connector and a metalized plastic backshell for your MS3X builds. See t...

    Add to cart
  • Crimp Connector for IGN-1 or IGN-1CD

    Crimp Connector for IGN-1 or IGN-1CD

     $7.29

    Metri-Pack crimp connector for wiring up IGN-1 or IGN-1CD coils. Like all of our 'ready to crimp' connectors- we include an extra terminal/pin, just in case you goof one up.

    Add to cart
  • Crimp Connector for IGN-4

    Crimp Connector for IGN-4

     $13.49

    Crimp connector and pins for IGN-4 coil. This is a standard "junior timer" sort of connector that has other uses such as Bosch crankshaft position sensors and throttle position sensors. Like all of our 'ready to crimp' connectors, we include an extra t...

    Add to cart
  • Crimp Connector for IGN-6

    Crimp Connector for IGN-6

     $5.99

    Included is a Weather Pack type connector for IGN-6 coils. The pins and seals are sized for 14 to 16 gauge wire. Like our other DIYAutoTune Weather Packs, we include an extra pin, just in case.

    Add to cart

  • Weather Pack 6 Position, 16-14 Gauge (3) Pack

    5 out of 5
    $14.00

    (3) 6 position  weather pack sets, including: (3) male and female connectors (19) male and female 16-14 gauge pins (38) 16-14 gauge seals

    Add to cart

  • Weather Pack 6 Position, 20-18 Gauge (3) Pack

     $15.00

    (3) 6 position  weather pack sets including: (3)  male and female connectors (19) male and female 20-18 gauge pins (38) 20-18 gauge seals

    Add to cart