$8.49
In stock
(3) 3 position weather pack sets including:
(3) male and female connectors,
(10) male and female 20-18 gauge pins, and
(20) 20-18 gauge seals
You must be logged in to post a comment.
This 3 wire pigtail connector fits a number of GM applications, including certain camshaft position sensors, fan switch sensors, and oil pressure sensors. Please check against your existing socket before ordering.
Add to cart
We've tracked down a source for a reliable, yet affordable, crimper for the Weather Pack connectors. This crimper is American made and truly creates a perfect crimp every time, without the price tag you'd usually pay for a Delphi 12014254 crimper.Th...
Add to cart
Run out of terminals for your Weather Pack kits (or bought a kit elsewhere that didn't have enough)? We have the pins and seals on their own, without any housings or other parts. This package contains 30 pairs of male and female Weather Pack terminals, pl...
Add to cart
Run out of terminals for your Weather Pack kits (or bought a kit elsewhere that didn't have enough)? We have the pins and seals on their own, without any housings or other parts. This package contains 30 pairs of male and female Weather Pack terminals, pl...
Add to cart
Our Weather Pack kits contains everything you need to get your project done right! We've used other connector kits available on the market in projects around the shop and they never quite met our expectations. So in typical DIYAutoTune style, we stepp...
Add to cart
(3) 2 position weather pack sets including:(3) male and female connectors (7) male and female 20-18 gauge pins (14) 20-18 gauge seals
Add to cart
Joe Claire
Working well for Traction Control and VSS. Going to try for Crank signal now.I have 2 of these already on the vehicle. One at the rear end pinion for VSS1 running on a 4 magnet wheel and one on the front hub reading the heads of the lug studs (6 lugs). Both are working well. I am going to try one on the front of the crank with a 36-1 wheel. I bought 2, one to keep as a spare, since I now have 3 on the vehicle.
Joe Claire
Well made, machines easily.Picture is very accurate. It machines easily and is well made. Should be a good improvement over my 8 window stock trigger.
vitaliy
Hall Effect Crankshaft Position SensorI bought this item, it's not dirt cheap to me. But, I purchased it. Using it with ms2 extra. Had to do few steps, solder few wires to make it work. Instructions online available step by step. It was easy enough and the felling was rewarding that I did it. The sensor works beautifully, it does the job very nicely, so far I have no complains. Would say much sharper than the pickup sensor for sure. (Project: rotary engine Rx7) thanks diyautotune.
Bahaa Al Rayes
Excellent kit
Fast Shipping
Great support
kristanci roberto
The better solutionsRobert,from Italy,
This is the better ,cheapiest solution to drive a Classic europea 4 cylinder engine.
I install on Classic Opel,20xe,16 e .
Have about 20 cars runs MS 2, and some of that runs micro,the quickest solutions.
Thanks DIY,Good device,hope it test cheap!!!