Innovate DB Gauge ONLY – Red – 37940

SKU: INNVT-3794

Add a Red DB Style Gauge to your existing Innovate LC-1 or LM-1, LC-2 or just about any wideband controller. The DB Series gauges connect to the analog output from your wideband system and provides you with accurate Air/Fuel Ratio information in real-time….. a good idea for high performance naturally aspirated cars, and pretty much…

-

460 Piece Weather Pack Kit

SKU: WPL_460-K

Our 460 Piece Weather Pack kits contains everything you need to get your project done right!  We’ve used other connector kits available on the market in projects around the shop, they never quite met our expectations to be honest.  So in typical DIYAutoTune style, we stepped it up and made them better!  We’ve included more…

-

755 Piece Weather Pack Kit

SKU: WPL_755-K

Our Weather Pack kits contains everything you need to get your project done right!  We’ve used other connector kits available on the market in projects around the shop and they never quite met our expectations.  So in typical DIYAutoTune style, we stepped it up and made them better!  We’ve included more than enough crimp terminals…

-

Weather Pack Bulkhead Connector Kit

SKU: WP22M-K

Use this giant 22 Position Weather Pack connector to run wires through a firewall or as a quick disconnect for your engine harness, or other components that need a lot of wires. Includes: (1) 22 position male and female connector (13) 20-18 gauge male and female pins (13) 16-14 gauge male and female pins (4)…

-

Innovate LC-1 Serial Cable – 37460

SKU: INNVT-3746

Innovate serial cable for the LC-1. Also can serve as a replacement serial cable for the VVTuner, MSPNP2-EEC4A8 or EEC4B8, and Microsquirt.

-

Wire – 2 Core Shielded Ignition Signal Wire 22 Gauge – 10′

SKU: Wire-Shlded2

Wire – Twin Core Shielded 22 Gauge Wire – 10′ Shielded twin core 22 gauge wire helps cut out interference — Perfect for Tach/Ignition Signal! This temperature resistant wire has two separate 22 gauge wires in the shield, making it perfect for variable reluctor sensors and other sensors that you want to send both the…

-

Wire – Single Core Shielded Ignition Signal Wire 20 Gauge – 10′

SKU: Wire-Shlded

Wire – Single Core Shielded Ignition Wire 20 Gauge – Length = 10′ Shielded single core 20 gauge wire helps cut out interference — Perfect for Tach/Ignition Signal! This temperature resistant wire has one 20 gauge wires in the shield. Has many other uses where you need to protect sensitive signals. Sold in 10′ lengths.…

-

Common MegaSquirt EMS Price Quotes

Common Quotes for a complete MegaSquirt System Some common price quotes for complete systems, both assembled and un-assembled in kit form.  This is to give you a rough idea and doesn’t cover all situations.  You may want to trim it down a bit, or need something else. Here’s a page with info on my recommendations…

Innovate Motorsports HBX-1 Heat Sink Bung Extender – 37290

SKU: INNVT-3729

Innovate Motorsports HBX-1 Heatsink Bung Extender – #3729 The Bosch wide-band O2 sensors included with Innovate wideband packages is rated to operate at an exhaust gas temperature of < 1300 degrees (F), and a sensor housing temperature of < 900 degrees (measured at the bung) for maximum accuracy and control. When either of these operating…

-

Weather Pack 5 Position, 16-14 Gauge (3) Pack

SKU: WP5B3-K

(3) 5 position  weather pack sets including: (3) male and female connectors (16) male and female 16-14 gauge pins (32) 16-14 gauge seals

-