Cart

Quick Links

Wire – 2 Core Shielded 22 Gauge – 10′

5 out of 5 based on 1 customer rating
(1 customer review )

$14.00

In stock

SKU: Wire-Shlded2 Category:

Description

Wire – Twin Core Shielded 22 Gauge – 10′

Shielded twin core 22 gauge wire helps cut out interference — Perfect for Tach/Ignition Signal! This temperature resistant wire has two separate 22 gauge wires in the shield, making it perfect for variable reluctor sensors and other sensors that you want to send both the positive and negative terminal to the ECU. On EDIS applications, this lets you shield both the SAW and PIP wires to the module. Has many other uses where you need to protect sensitive signals.

Sold in 10′ lengths. If you purchase more than one 10′ length we’ll give you a single solid piece, not individually 10′ pieces so you can cut it to length as needed.

Customer reviews

Rated 5 out of 5 stars
1 review
4 stars 0 0 %
3 stars 0 0 %
2 stars 0 0 %
1 star 0 0 %

1 review for Wire – 2 Core Shielded 22 Gauge – 10′

  1. 5 out of 5

    Working well for Traction Control and VSS. Going to try for Crank signal now.I have 2 of these already on the vehicle. One at the rear end pinion for VSS1 running on a 4 magnet wheel and one on the front hub reading the heads of the lug studs (6 lugs). Both are working well. I am going to try one on the front of the crank with a 36-1 wheel. I bought 2, one to keep as a spare, since I now have 3 on the vehicle.

    Was this review helpful to you? 0 of 0 people found this review helpful

  2. 5 out of 5

    Well made, machines easily.Picture is very accurate. It machines easily and is well made. Should be a good improvement over my 8 window stock trigger.

    Was this review helpful to you? 0 of 0 people found this review helpful

  3. 5 out of 5

    Hall Effect Crankshaft Position SensorI bought this item, it's not dirt cheap to me. But, I purchased it. Using it with ms2 extra. Had to do few steps, solder few wires to make it work. Instructions online available step by step. It was easy enough and the felling was rewarding that I did it. The sensor works beautifully, it does the job very nicely, so far I have no complains. Would say much sharper than the pickup sensor for sure. (Project: rotary engine Rx7) thanks diyautotune.

    Was this review helpful to you? 0 of 0 people found this review helpful

  4. 5 out of 5

    Excellent kit
    Fast Shipping
    Great support

    Was this review helpful to you? 0 of 0 people found this review helpful

  5. 5 out of 5

    The better solutionsRobert,from Italy,
    This is the better ,cheapiest solution to drive a Classic europea 4 cylinder engine.
    I install on Classic Opel,20xe,16 e .
    Have about 20 cars runs MS 2, and some of that runs micro,the quickest solutions.
    Thanks DIY,Good device,hope it test cheap!!!

    Was this review helpful to you? 0 of 0 people found this review helpful

Add a review

Questions & Answers