Search Results for: usb serial/feed/rss2/
Twin Turbocharging our Nova: One Step at a Time Part1: Main Turbo Conversion
Way too much turbo, way too little motor. Should be fun. Oil System Parts List To order the parts needed for the oil system, I just started at the oil source, which is the oil pressure port on the block near the rear of the drivers side head, and envisioned each connection to the turbos…
Read MoreFully Assembled Wire-In EMS Systems
Contact our Technical Sales Team to discuss the perfect system for your Engine Management Needs! Email us at [email protected] with some details on your vehicle, engine and and must-have features and we’ll make sure you’re pointed in the right direction! Ready to Rock Engine Management Systems ready to wire and fire! MS3Pro Sequential Electronic…
Read MoreWhat do I need?
Another question that doesn’t have a quick short answer… but the quick short answer is: An ECU (there are a few options here of course), a stimulator (95% required), and a tuning cable. Optionally you may need a USB-Serial Converter if your laptop doesn’t have a DB9 serial port, and/or a Wideband O2 system such…
Read MoreMegaSquirt Carb to EFI Conversion – Part 1: TBI Fuel Only
From Carb to EFI on just a fistful of dollars… Updated 3/3/09 – Added dyno chart showing comparison of readings taken on old vs new dyno. Objective of this Article This article will walk you through the process of installing a MegaSquirt EFI system on a classic carb’d vehicle attempting to go the least expensive…
Read MoreTwin Turbocharging Our Nova: One Step at a Time Part1: Main Turbo Conversion
Way too much turbo, way too little motor. Should be fun. Oil System Parts List To order the parts needed for the oil system, I just started at the oil source, which is the oil pressure port on the block near the rear of the drivers side head, and envisioned each connection to the turbos…
Read More
The EFI Tuners Guide Chapter 5B -The EFI Fuel System: Fuel Tanks and Pumps
Understanding EFI Fuel Systems and Fuel Pump needs for your project. How to convert your carb’d fuel tank over for use with Electronic Fuel Injection on a Carb-To-EFI project, and what to consider when upping the power output of your factory EFI engine.
Read MoreMain Board Assembly
First, you will want to decide which components you will be using, as not all installations need all components. Here is a list of what parts go with what circuit. Note that U3 is used for multiple circuits, and must be installed for any of the circuits to work. There are a couple parts that…
Read MoreTroubleshooting
Problem: Power is applied to the VVTuner, but the LED does not illuminate. Solution 1: Confirm that the polarity is not reversed on the VVTuner connector. Solution 2: Confirm that the wires are connected in the proper locations on the VVTuner connector. Solution 3: Confirm the voltage supplied to the VVTuner is no less than…
Read MoreCommunication Settings
Before establishing a connection between the laptop and the VVTuner CCM, the user must ensure proper communications settings. Furthermore, the serial port must not be in use by another program or application. You’ll need a 2.5 mm serial cable such as the Innovate / Microsquirt tuning cable. The default VVTuner comm port setting is “COM1”.…
Read MoreMustang 5.0 MS2 + PNP Adaptor Harness kit
Note: The adapter harness kit is discontinued. This page is for reference for people still using this harness. You’ve received the MS2 3.57 Mustang PNP kit. What do you do now? Step 1: Read, read read!! All instructions and documentation are available online. We have a tech article written about the EEC-IV adapter, available…
Read More