Showing all 9 results
CANEGT 8 Channel Thermocouple Interface
$350.00The CANEGT 8 Channel Thermocouple Interface allows you to monitor up to 8 K-type thermocouples AND up to 8 Innovate wideband devices over an Innovate Log Chain, and can transmit the data to a MegaSquirt-II, MegaSquirt-III, MicroSquirt, MSPNP, or MS3Pro o...
Add to cartOpen Tip EGT Probe Black Stinger
$73.00Measure your exhaust gas temperature per bank or per cylinder with this open tip EGT probe. It is a K type thermocouple with an 8 foot lead. The open tip EGT probe reads slightly faster than an enclosed tip probe, but tends to wear faster in extreme heat ...
Add to cartClosed Tip EGT Probe Red Avenger
$62.00Measure your exhaust gas temperature per bank or per cylinder with a longer lasting, closed tip EGT probe, a K type thermocouple with an 8 foot lead. The open tip probe reads slightly faster than a closed tip EGT Probe, but tends to wear faster in extreme...
Add to cartStainless Steel EGT Weld-In Compression Fitting
$15.00Got a stainless steel exhaust? Here's what you need to install an EGT probe in it. Weld this compression fitting into your headers or exhaust pipe. It holds a EGT probe securely in place. Compression type fitting provides a leak-free seal that holds up at...
Add to cartMild Steel EGT Weld-In Compression Fitting
$12.00Weld this compression fitting into your headers or exhaust pipe. It holds a EGT probe securely in place. Compression type fitting provides a leak-free seal that holds up at high temperatures.
Add to cartStainless Steel EGT 1/8″ NPT Compression Fitting
$14.00Need a weld-free way to add EGT fittings to a cast iron manifold? Drill and tap it for 1/8" NPT pipe thread and bolt one of these in! Works with our Red Avenger and Black Stinger thermocouples.
Add to cartEGT Clamp and Fitting
$16.49Attach an EGT probe to your exhaust without welding using this worm drive clamp and compression fitting. Fits 1.56" to 2.5" OD tube headers or exhaust pipes, with a 3/16" compression fitting for use with our EGT probes. Made from stainless steel.
Add to cartEGT Port Cap Kit – Package of 3
$11.49Removing your EGT probes? Seal the hole with these cap kits.Note: These will not fit our thread in fittings (EGT_0004). If using the thread in fittings, you will need to unscrew the fitting and replace with a 1/8" NPT pipe plug instead. They will fit ...
Add to cart