Description
16 pin connector with pre-crimped 8″ black wires. Included with MSPNP-MM9093 and MSPNP-MM9495 for extra inputs and outputs. Can also be used with DIYPNPN76-K, DIYBOB-N76K, or to repair a factory wiring harnesses.
This module protects your engine or transmission controller from high voltage spikes being fed in through digital inputs. The AXM-110 module can take 1,500 volts peak and 33.5 volts continuous. Common uses for the AXM-110 high voltage isolator include: ...
Add to cartIncluded is an 8' long harness for installing the MicroSquirt on larger vehicles instead of motorcycles and ATVs. Serial cable included.
Add to cartMany older tachometers trigger off the negative terminal of the ignition coil. Often, these use a filtering circuit which will not trigger when given a 0 to 12 volt square wave signal, such as the tach output signal from an ECU or ignition box. If you h...
Add to cartThis electronic boost control solenoid can be used with the MS3-Pro/MSPNP as well as any DIY Style MegaSquirt EMS (with the appropriate mods), or with other electronic boost controllers to control boost by adjusting the pressure to a turbo wastegate. Th...
Add to cartThis pigtail has 10" leads and fits Ford TFI ignition coils. Used on 5.0 Mustangs, injected 351 Windsor motors, the 2.3 Turbo, various incarnations of the 3.8 V6, and many others. Just the thing if you're making a new wiring harness for your 5.0 or other ...
Add to cartBosch EV1 style Fuel Injector connector with uncrimped pins. Includes one connector and two uncrimped pins (actually, we throw a third pin in just in case) Fits a wide variety of cars that use Bosch injectors, including many Ford, GM, and BMW produ...
Add to cart
1 review for MSPNP 16 Pin Center Connector