Description
16 pin connector with pre-crimped 8″ black wires. Included with MSPNP-MM9093 and MSPNP-MM9495 for extra inputs and outputs. Can also be used with DIYPNPN76-K, DIYBOB-N76K, or to repair a factory wiring harnesses.
This FTDI chipset USB to Serial Adapter has been tested and works properly with all of our ECU products and all versions of TunerStudio on a wide range of operating systems. This is probably the most common item we see people come back for after a purch...
Add to cartThis electronic boost control solenoid can be used with the MS3-Pro/MSPNP as well as any DIY Style MegaSquirt EMS (with the appropriate mods), or with other electronic boost controllers to control boost by adjusting the pressure to a turbo wastegate. Th...
Add to cartMany older tachometers trigger off the negative terminal of the ignition coil. Often, these use a filtering circuit which will not trigger when given a 0 to 12 volt square wave signal, such as the tach output signal from an ECU or ignition box. If you h...
Add to cartIAC Pigtail (6") for Jeep Stepper Motor Idle Air Controllers This is the wiring pigtail to compliment DarkStar's IAC Valve body complete with detailed assembly instructions (it's super easy- basically just plug them in) so that you can color code the w...
Add to cartReplacement M8 to DB9 serial cable. This cable is used for certain plug and play applications where there wasn't room for a regular DB9 connector, including the following: MS3Pro PNP for '84-'87 Buick Regal 3.8 Turbo MSPNP Gen 2 for '86-'93 Ford M...
Add to cartGM Style 3-pin TPS Pigtail used in many GM applications, as well as others.... 6" Pigtail, pre-crimped, ready for your harness.
Add to cart
1 review for MSPNP 16 Pin Center Connector