$7.49
In stock
10-pack of wire jumpers in 5 colors. These fit 0.1″ headers and are used on the JimStim to make connections for testing additional circuitry. There are several other uses for them too.
Only logged in customers who have purchased this product may write a review.
What sort of pins does this fit?
Part # MS130-K; MegaSquirt-I Programmable EFI System with V3.0 main board - Unassembled Kit with Black CaseImportant Note: The BIP373 coil driver is sold separately and is only required for direct coil control. If you are using coils with internal or ...
Add to cart
MegaSquirt-II Engine Management System with 3.0 Main Board - UnAssembled Kit; Part # MS230-K_m4Important Note: The BIP373 coil driver is sold separately and is only required for direct coil control. If you are using coils with internal or external ig...
Add to cart
MegaSquirt-II Engine Management System with 3.0 main board - Unassembled Kit with Black Case; Part # MS230-KImportant Note: The BIP373 coil driver is sold separately and is only required for direct coil control. If you are using coils with intern...
Add to cart
Use this board to test the MegaSquirt's inputs and outputs on the bench, before you install it on a car!The JimStim features a microcontroller which allows the simulation of up to 30 different toothed wheels, in addition to the standard distributor s...
Add to cart
DIYAutoTune Part# JimStim-CJimStim is essentially an engine simulator, a microcontroller which allows the generates up to 30 different toothed wheel signals, in addition to the standard distributor signal. Test your RPM input on the Stim, or tell the ...
Add to cart
The regular JimStim can test the main board on your MS3. But what if you'd like to see the inputs and outputs on the MS3X expansion card in action, too? Now it's easy - just add a JimStimX! Use the three pull-off jumpers on the JimStim to connect the 5 vo...
Add to cart
1 review for Jumper 10-Pack