Description
16 pin connector with pre-crimped 8″ black wires. Included with MSPNP-MM9093 and MSPNP-MM9495 for extra inputs and outputs. Can also be used with DIYPNPN76-K, DIYBOB-N76K, or to repair a factory wiring harnesses.
Many older tachometers trigger off the negative terminal of the ignition coil. Often, these use a filtering circuit which will not trigger when given a 0 to 12 volt square wave signal, such as the tach output signal from an ECU or ignition box. If you h...
Add to cartMegaSquirt Wiring Bundle - 23" Long Perfect for creating your harness adapter (perhaps using a DIYBOB along with this) or for tying into your stock wiring harness! 23" TXL wire, color coded with labeling printed on the wire every 3 inches -- no ...
Add to cartReplacement M8 to DB9 serial cable. This cable is used for certain plug and play applications where there wasn't room for a regular DB9 connector, including the following: MS3Pro PNP for '84-'87 Buick Regal 3.8 Turbo MSPNP Gen 2 for '86-'93 Ford M...
Add to cartIAC Pigtail (6") for Jeep Stepper Motor Idle Air Controllers This is the wiring pigtail to compliment DarkStar's IAC Valve body complete with detailed assembly instructions (it's super easy- basically just plug them in) so that you can color code the w...
Add to cartUse this module to convert the sine wave signal from a VR (variable reluctor) signal into an easy to handle square wave hall sensor style signal. The AXM-120 VR conditioner works with camshaft position, crankshaft position, vehicle speed, or similar sen...
Add to cart
1 review for MSPNP 16 Pin Center Connector