Description
12 pin connector with pre-crimped 8″ black wires. Included with MSPNP-MM9697 for extra inputs and outputs. Can also be used to repair factory wiring harnesses.
12 pin connector with pre-crimped 8″ black wires. Included with MSPNP-MM9697 for extra inputs and outputs. Can also be used to repair factory wiring harnesses.
TPS-3 Connector (Uncrimped) GM Style 3-pin TPS Connector complete with: the 3-pin connector three pins plus an extra fourth pin (just in case)
Add to cartMany older tachometers trigger off the negative terminal of the ignition coil. Often, these use a filtering circuit which will not trigger when given a 0 to 12 volt square wave signal, such as the tach output signal from an ECU or ignition box. If you h...
Add to cart10-pack of wire jumpers in 5 colors. These fit 0.1" headers and are used on the JimStim to make connections for testing additional circuitry. There are several other uses for them too.
Add to cartThis electronic boost control solenoid can be used with the MS3-Pro/MSPNP as well as any DIY Style MegaSquirt EMS (with the appropriate mods), or with other electronic boost controllers to control boost by adjusting the pressure to a turbo wastegate. Th...
Add to cartBosch EV1 style Fuel Injector connector with uncrimped pins. Includes one connector and two uncrimped pins (actually, we throw a third pin in just in case) Fits a wide variety of cars that use Bosch injectors, including many Ford, GM, and BMW produ...
Add to cartDB15 pigtail harness. Used for optional outputs on the expansion connector on V3.57 boards and for the V1.2 version of the MSPNP Gen 2 (the version with the red main board).
Add to cart
Reviews
There are no reviews yet.