Description
12 pin connector with pre-crimped 8″ black wires. Included with MSPNP-MM9697 for extra inputs and outputs. Can also be used to repair factory wiring harnesses.
12 pin connector with pre-crimped 8″ black wires. Included with MSPNP-MM9697 for extra inputs and outputs. Can also be used to repair factory wiring harnesses.
Weatherpack style connector for GM boost control solenoid. This connector comes with crimp-on pins to keep the number of splices in your wiring harness to a minimum. Note: This connector is not needed for our newer style (12/2008 and newer) non-GM EBC ...
Add to cartThis module protects your engine or transmission controller from high voltage spikes being fed in through digital inputs. The AXM-110 module can take 1,500 volts peak and 33.5 volts continuous. Common uses for the AXM-110 high voltage isolator include: ...
Add to cartMany older tachometers trigger off the negative terminal of the ignition coil. Often, these use a filtering circuit which will not trigger when given a 0 to 12 volt square wave signal, such as the tach output signal from an ECU or ignition box. If you h...
Add to cart10-pack of wire jumpers in 5 colors. These fit 0.1" headers and are used on the JimStim to make connections for testing additional circuitry. There are several other uses for them too.
Add to cartTPS-3 Connector (Uncrimped) GM Style 3-pin TPS Connector complete with: the 3-pin connector three pins plus an extra fourth pin (just in case)
Add to cartThis FTDI chipset USB to Serial Adapter has been tested and works properly with all of our ECU products and all versions of TunerStudio on a wide range of operating systems. This is probably the most common item we see people come back for after a purch...
Add to cart
Reviews
There are no reviews yet.