Description
12v DC Power Supply Plugs directly into your MegaSquirt JimStim Stimulator!
Power supply supports 120 to 240 volt AC power.
Customers' review
1 review for MegaSquirt JimStim Stimulator Power Supply
Add a review
You must be logged in to post a comment.
What are the power input requirements for this power supply?
- It is compatible with 120-240 VAC @ 50-60Hz. The power supply includes 5 different plugs for use in most/all major markets.
What is the power output of the supply?
- Output is regulated 12V DC, max 500mA. This will power a MegaSquirt ECU for bench testing, but don’t try to run large electronics off of it.
What is the polarity of the plug on the output side?
- Center pin is positive.
Will this work on an MSPNP, MicroSquirt, or MS3-Pro?
- It will not plug directly into any of these units, and these do not plug into a Stim or JimStim either. You would need to make some sort of adapter harness to use this power supply with one of these ECUs.
Questions & Answers
Related Products
JimStim v1.5 MegaSquirt Stimulator with Wheel Simulator – Unassembled
$80.00Use this board to test the MegaSquirt's inputs and outputs on the bench, before you install it on a car!The JimStim features a microcontroller which allows the simulation of up to 30 different toothed wheels, in addition to the standard distributor s...
Add to cart-
D-Sub Connector Pin Removal Tool
$4.50Need to remove a pin from one of our assembled MegaSquirt harnesses? These little tools are what you need to release the pins from a D-Subminiature connector so you can pull the wire out.
Add to cart -
JimStim 1.5 MegaSquirt Stimulator with Wheel Simulator – Assembled
From: $120.00DIYAutoTune Part# JimStim-CJimStim is essentially an engine simulator, a microcontroller which allows the generates up to 30 different toothed wheel signals, in addition to the standard distributor signal. Test your RPM input on the Stim, or tell the ...
Add to cart -
Weather Pack Pin Removal Tool
$4.99This tool makes de-pinning Weather Pack connectors a simple snap or poke.Just pop the seal retainer off, poke the tool in from the terminal side, slipping the tool over the terminal all the way in to release the latch, and pull the wire out from the...
Add to cart -
Jumper 10-Pack
$7.4910-pack of wire jumpers in 5 colors. These fit 0.1" headers and are used on the JimStim to make connections for testing additional circuitry. There are several other uses for them too.
Add to cart -
Anti-Static ESD Protection Wrist Strap
$5.49Anti-Static ESD Protection Wrist StrapProtect your electronics from Electrostatic Discharge (ESD) during assembly or modification. Attach this wrist strap by connecting the clip to a good ground point and you'll safely discharge all static electricity...
Add to cart
deric
A must have for the stimulator! Great price! Great customer service!