facebook_pixel
Cart

Quick Links

HSD-4 High Side Driver with 4 channels

5.00 out of 5 based on 1 customer rating
(1 customer review )

$82.95

In stock

Description

Have an application with a lot of small solenoids that need 12V power and rapid switching? Don’t want the expense of a bank of four separate solid state relays, each rated for five times the current each solenoid needs? This module lets you run up to four medium current 12 volt devices with high speed solid state switching.

The HSD-4 module provides four high side drivers for solenoids that need 12 volt power instead of ground. Wire a ground triggered output from an MS3Pro, MicroSquirt, or MegaSquirt to the HSD-4’s input, and it will supply a 12 volt output with up to 8 amps of current. Use it for medium current solenoids that have to be switched faster than a mechanical relay. Applications for the HSD-4 high side driver include:

  • Toyota A340 and A341 transmissions
  • Subaru W4A33 transaxles
  • BMW Double VANOS variable valve timing solenoids

Most applications that require an HSD-4 have the solenoid ground connected to the solenoid body and a single wire supplying 12V to the solenoid.

The HSD-4 high side driver is epoxy potted for maximum vibration and water resistance. Suitable for underhood applications.

Customers' review

Rated 5.00 out of 5 stars
1 review
4 stars 0 0 %
3 stars 0 0 %
2 stars 0 0 %
1 star 0 0 %

1 review for HSD-4 High Side Driver with 4 channels

  1. 5 out of 5

    Works on A340 Toyota trans.I used this with a Microsquirt transcontroller . It allowed me to drive my solenoids with 12 volts instead of ground. Works better than relays as these respond faster. No heat issues works good!

    Was this review helpful to you? 0 of 0 people found this review helpful

Add a review

Where is this product manufactured?

  • The HSD-4 high side driver is proudly manufactured in Gainesville, Georgia, USA.

How does this wire up to my ECU?

Is it possible to use the HSD-4 high side driver module with a brand [enter your brand here] ECU?

  • Probably. Most ground switched outputs will activate the HSD-4.

Can I use the HSD-4 high side driver with nitrous solenoids?

  • Check the coil resistance before wiring this to a nitrous solenoid, as the HSD-4 will not supply more than 8 amps per channel. We do not recommend using the HSD-4 with a solenoid if the coil resistance is under 2 ohms.

Can I trigger two or more outputs with a single input?

  • Yes, you can wire multiple input wires to a single ground triggered output on your ECU if you want the HSD-4 to activate several devices at once.

Questions & Answers

There are no questions yet, be the first to ask something for this product.

Send me a notification for each new answer.