$21.00
DB26 pigtail connector, as used with the latest MSPNP Gen 2 for its 26 pin expansion connector. Includes 6″ pre crimped wires. Poke in the ones you need, leave out the ones you don’t.
Only logged in customers who have purchased this product may write a review.
Many older tachometers trigger off the negative terminal of the ignition coil. Often, these use a filtering circuit which will not trigger when given a 0 to 12 volt square wave signal, such as the tach output signal from an ECU or ignition box. If you h...
Add to cart
Important Note: The original USB2920 was discontinued by its manufacturer. We are now providing an updated part, but we are continuing using the same part number to make it easy for you to find. This FTDI chipset USB to Serial Adapter has been tested...
Add to cart
Replacement M8 to DB9 serial cable. This cable is used for certain plug and play applications where there wasn't room for a regular DB9 connector, including the following:MS3Pro PNP for '84-'87 Buick Regal 3.8 Turbo MSPNP Gen 2 for '86-'93 Ford M...
Add to cart
MegaSquirt Relay Board - Assembled Unit - Part# MSRelay-CThough the Relay/Power Board is not required, it is a convenience and can reduce the chance of miswiring during the installation. The relay board provides a central place for all of the required...
Add to cart
Three pin, GM WeatherPack style, inline throttle position sensor. Fits the TPS on many GM TPI installations, Holley Stealth Ram and Pro-Jection, and Rochester feedback carburetors. Note the keying, shown in the product gallery zoom.
Add to cart
Bosch EV1 style Fuel Injector connector with uncrimped pins. Includes one connector and two uncrimped pins (actually, we throw a third pin in just in case)Fits a wide variety of cars that use Bosch injectors, including many Ford, GM, and BMW produ...
Add to cart
2 reviews for DB26 Pigtail Harness