For upgrading your Megasquirt-I ECU, or replacement of your damaged MegaSquirt-II daughterboard. MS2 daughter cards are for use only with genuine Bowling & Grippo MegaSquirt mainboard PCBs. This is the latest version of the MegaSquirt-II daughterboard with the C64 processor and is CAN-enabled. The latest embedded code can be found at the MS2/Extra downloads page.
You can install it as an upgrade, although the MS2 / V2.2 combination is not as well documented or up to date as the MS2 / V3.0 or MS2 / V3.57. See the MS2/Extra archive web manuals for notes about this combination.
Will this fit both a PNPMS2 as well as the generic DIY MS2 kit?
QWill this fit both a PNPMS2 as well as the generic DIY MS2 kit?
Asked by Ray
The MSPNP Gen 2 is based on the MicroSquirt Module and does not use an MS2 daughterboard.
Is the MS2 daughter board a kit, or assembled? And, is this MS2 extra? fuel and spark?
QIs the MS2 daughter board a kit, or assembled? And, is this MS2 extra? fuel and spark?
Asked by Mark
The daughter board is assembled and ready to drop onto a MegaSquirt main board. It ships without firmware but can be loaded with Bowling & Grippo code or MS2/Extra. Loading code can be done with an ordinary serial cable and a laptop, no special tools required, and takes about five minutes.
Only registered users are eligible to enter questions
This MSx30-Guts kit includes all the capacitors, diodes, integrated circuits, resistors, transistors, ECU connectors, the tube of heatsink compound and a bit of jumper wire in a Megasquirt V3.0 kit. The kit does not include the V3.0 PCB, case, endplates, ...
MegaSquirt Relay Board - Assembled Unit - Part# MSRelay-C
Though the Relay/Power Board is not required, it is a convenience and can reduce the chance of miswiring during the installation. The relay board provides a central place for all of the required...
MegaSquirt-I PCBv3.0 Partial Kit
PCBv3.0, MegaSquirt-I CPU and MPX4250 MAP Sensor for building a MegaSquirt-I PCB 3.0 ECU. Complete Bill of Materials (parts listing) and assembly instructions can be found HERE .
Click HERE for complete MegaSquirt-...
Note: Now using a brushed silver finish MS3 enclosure, which will help facilitate potential future upgrades from MS2 to MS3 without extra cost!
MegaSquirt-II Engine Management System with 3.0 main board - Unassembled Kit; Part # MS230-K
MegaSquirt-II PCBv3.0 Partial Kit
PCBv3.0, MegaSquirt-II daughterboard and MPX4250 MAP Sensor for building a MegaSquirt-II PCB 3.0 ECU.
Complete Bill of Materials (parts listing) and assembly instructions can be found HERE .
Click HERE for comp...
7 reviews for CPU – MegaSquirt-II Daughterboard