$10.50
In stock
Metal DB37 Cover with Hardware and Gaskets
This Metal DB37 cover is perfect for building up your own Megasquirt wiring harness or relay cable connector.
You must be logged in to post a comment.
MegaSquirt Wiring Bundle8' TXL wire, color coded with labeling printed on the wire every 3 inches -- no paper tags here! IAC and Ignition wires are included for MS-I / MS-2 use (or MS-3 Primary Harness use) Shielded Ignition input wireGrea...
Add to cart
DB9 6' Male/Female Straight thru cable for tuning and testing your MegaSquirt ECU.
Add to cart
MegaSquirt-II Engine Management System with 3.0 main board - Unassembled Kit with Black Case; Part # MS230-KImportant Note: The BIP373 coil driver is sold separately and is only required for direct coil control. If you are using coils with intern...
Add to cart
MegaSquirt-II Engine Management System with 3.0 Main Board - UnAssembled Kit; Part # MS230-K_m4Important Note: The BIP373 coil driver is sold separately and is only required for direct coil control. If you are using coils with internal or external ig...
Add to cart
Upgrading your MS1 or MS2 to the latest MS3 has never been easier with this processor replacement! We've packaged the MS3 daughter board with 2 of the 40 pin sockets, so it will match up with our cases (required for upgrade) which have cutouts for the SD ...
Add to cart
vitaliy
Hall Effect Crankshaft Position SensorI bought this item, it's not dirt cheap to me. But, I purchased it. Using it with ms2 extra. Had to do few steps, solder few wires to make it work. Instructions online available step by step. It was easy enough and the felling was rewarding that I did it. The sensor works beautifully, it does the job very nicely, so far I have no complains. Would say much sharper than the pickup sensor for sure. (Project: rotary engine Rx7) thanks diyautotune.
Bahaa Al Rayes
Excellent kit
Fast Shipping
Great support
kristanci roberto
The better solutionsRobert,from Italy,
This is the better ,cheapiest solution to drive a Classic europea 4 cylinder engine.
I install on Classic Opel,20xe,16 e .
Have about 20 cars runs MS 2, and some of that runs micro,the quickest solutions.
Thanks DIY,Good device,hope it test cheap!!!
Anthony
Well MadeA very clean installation - fit the v3.0 board perfectly. I won't go back to drilling and filing my own end plates.
Anthony
Huge Upgrade from MS1Very easy to swap out my MS1 processor for an MS2. Much faster and more functionality from 16x16 tables to stepper-style IAC to expanded trigger wheel options. Very happy.