Description
TO-220 heat sink as used on coil drivers for the DIYPNP. V1.1 DIYPNPs also used these for the voltage regulator, boost control, and a few other functions.
$2.00
-
TO-220 heat sink as used on coil drivers for the DIYPNP. V1.1 DIYPNPs also used these for the voltage regulator, boost control, and a few other functions.
There are no questions yet, be the first to ask something for this product.
Inductor replacement 2 - pack M7010-ND MSx30 and MS122 L1 and L2
Add to cart1/8" vacuum Y-fitting, as included in the MSPNP and Mustang plug and play packages. This is made of clear polycarbonate. Maximum pressure 125 psi. This plastic is tough enough to take 275 degree F engine temps, and won't crack even if exposed to Siberian ...
Add to cartReplacement thumb screw, as used on our wiring harnesses. Sold individually.
Add to cartTo make sure you can't accidentally switch the upper and lower harnesses, the MS3X harness uses a male DB37 connector instead of a female one. We've packaged a DB37 male solder cup connector and a metalized plastic backshell for your MS3X builds. See t...
Add to cartHeat Sink Machined for MegaSquirt PCB version 3.0 Part# MSx30-HS
Add to cartIncluded is a Heat Sink Machined for MegaSquirt GPIO Board Part # GPIO-HS Similar to our V3.0 heat sink, but this one is made specifically for the GPIO board from 1/8" aluminum.
Add to cart
Reviews
There are no reviews yet.