$9.50
In stock
Heat Sink Machined for MegaSquirt PCB version 3.0
Part# MSx30-HS
You must be logged in to post a comment.
Where is this heat sink made?
MegaSquirt MS3X Wiring Harness - 8 feet8' of TXL High temp automotive grade wire. Color coded wiring with labeling printed on the wire every 6 inches -- no paper tags here! All wiring is pre-crimped (NOT solder cupped!) to the DB37 Heavy d...
Add to cart
MegaSquirt-III Engine Management System w/PCB3.0 - Unassembled Kit Part # MS330-K_m4Important Note: The BIP373 coil driver is sold separately and is only required for direct coil control. If you are using coils with internal or external ignition modul...
Add to cart
MegaSquirt Relay Board - Assembled Unit - Part# MSRelay-CThough the Relay/Power Board is not required, it is a convenience and can reduce the chance of miswiring during the installation. The relay board provides a central place for all of the required...
Add to cart
MegaSquirt Wiring Bundle8' TXL wire, color coded with labeling printed on the wire every 3 inches -- no paper tags here! IAC and Ignition wires are included for MS-I / MS-2 use (or MS-3 Primary Harness use) Shielded Ignition input wireGrea...
Add to cart
DIYAutoTune Part# JimStim-CJimStim is essentially an engine simulator, a microcontroller which allows the generates up to 30 different toothed wheel signals, in addition to the standard distributor signal. Test your RPM input on the Stim, or tell the ...
Add to cart
The regular JimStim can test the main board on your MS3. But what if you'd like to see the inputs and outputs on the MS3X expansion card in action, too? Now it's easy - just add a JimStimX! Use the three pull-off jumpers on the JimStim to connect the 5 vo...
Add to cart
Reviews
There are no reviews yet.