$19.00
-
This 3 position pigtail fits certain 3 wire GM Mass Air Flow MAF sensors, as well as LS1 camshaft position sensors and crankshaft position sensors. See image to verify this is the GM MAF Connector you’re looking for!
Replaces GM part number 12085495
Will this fit an LS7 or other 58X crankshaft position sensor?
There are no questions yet, be the first to ask something for this product.
Add a crankshaft position sensor to your engine with our laser cut 36-1 crank trigger wheel. This trigger wheel is 6 3/4" in diameter and 1/8" thick, with a 1/2" diameter center hole (with plenty of room to enlarge it for larger crank bolts). The teeth ar...
Add to cart
Crank Position Sensor - Hall Effect tab mount Hall effect crank position sensor (or camshaft position sensor, or wheelspeed, or driveshaft speed, anything that spins!). We've tested this with our 6.75" and 8.25" trigger wheels. We were able to get a rock...
Add to cart
DL32 Datalogger and Sensor Controller The DL-32 is a complete vehicle-mounted data-logging system for advanced engine tuning. The system is anchored by Innovate's award-winning digital wideband air/fuel ratio technology, but also includes flexible sens...
Add to cart
Measure your exhaust gas temperature per bank or per cylinder with this open tip EGT probe. It is a K type thermocouple with an 8 foot lead. The open tip EGT probe reads slightly faster than an enclosed tip probe, but tends to wear faster in extreme heat ...
Add to cart
Removing your EGT probes? Seal the hole with these cap kits. Note: These will not fit our thread in fittings (EGT_0004). If using the thread in fittings, you will need to unscrew the fitting and replace with a 1/8" NPT pipe plug instead. They will fit ...
Add to cart
IAC Valve Connector (Uncrimped) Complete with the connector, four pins, plus an extra pin (just in case)
Add to cart
Reviews
There are no reviews yet.