Description
Plug and pin set for a GM 3-bar MAP sensor. We include an extra pin and wire seal just in case you need it as well.
Also available as a pigtail, if preferred.
4 wire pigtail connector that fits a variety of Ford applications. This connector has been used on many Ford 4 wire MAF sensors from 1984 through the mid 1990s, certain MAP sensors, and many 6 cylinder distributorless ignition coils including EDIS applica...
Add to cart4' Flying lead smart coil pigtail for IGN-1A coils. The extra length makes these easy to bundle up into a single ignition control harness without needing splices near the coil. Power and primary ground wires are 18 gauge to better handle these coils' p...
Add to cartGM Style 3-pin TPS Pigtail used in many GM applications, as well as others.... 6" Pigtail, pre-crimped, ready for your harness.
Add to cartMetri-Pack crimp connector for wiring up IGN-1 or IGN-1CD coils. Like all of our 'ready to crimp' connectors- we include an extra terminal/pin, just in case you goof one up.
Add to cartGM Mass Air Flow Sensor Pigtail - 3 position This 3 position pigtail fits certain 3 wire GM Mass Air Flow MAF sensors, as well as LS1 camshaft position sensors and crankshaft position sensors. See image to verify this is the GM MAF Connector you're loo...
Add to cartThese are the proper GM-style sensors for use with the MegaSquirt line of ECUs and come with the weatherproof connector and crimp pins. One extra crimp pin is included as a spare. The threads are 3/8" NPT pipe thread - note that isn't an actual 3/8" o...
Add to cart
Reviews
There are no reviews yet.