Description
16 pin connector with pre-crimped 8″ black wires. Included with MSPNP-MM9093 and MSPNP-MM9495 for extra inputs and outputs. Can also be used with DIYPNPN76-K, DIYBOB-N76K, or to repair a factory wiring harnesses.
Replacement M8 to DB9 serial cable. This cable is used for certain plug and play applications where there wasn't room for a regular DB9 connector, including the following: MS3Pro PNP for '84-'87 Buick Regal 3.8 Turbo MSPNP Gen 2 for '86-'93 Ford M...
Add to cart10-pack of wire jumpers in 5 colors. These fit 0.1" headers and are used on the JimStim to make connections for testing additional circuitry. There are several other uses for them too.
Add to cartDB15 pigtail harness. Used for optional outputs on the expansion connector on V3.57 boards and for the V1.2 version of the MSPNP Gen 2 (the version with the red main board).
Add to cartMany older tachometers trigger off the negative terminal of the ignition coil. Often, these use a filtering circuit which will not trigger when given a 0 to 12 volt square wave signal, such as the tach output signal from an ECU or ignition box. If you h...
Add to cartMegaSquirt Relay Board - Assembled Unit - Part# MSRelay-C Though the Relay/Power Board is not required, it is a convenience and can reduce the chance of miswiring during the installation. The relay board provides a central place for all of the required...
Add to cartGM Style 3-pin TPS Pigtail used in many GM applications, as well as others.... 6" Pigtail, pre-crimped, ready for your harness.
Add to cart
1 review for MSPNP 16 Pin Center Connector