Description
MPX4250AP MAP Sensor Standard 2.5 bar Map Sensor used in MegaSquirt PCB 2.2/3.0/3.57 ECUs.
Good for 21-22psi of boost, or for NA usage in non-boosted applications.
MPX4250 2.5 Bar MAP Sensor
$33.00
In stock
Customer reviews
2 reviews for MPX4250 2.5 Bar MAP Sensor
Add a review
You must be logged in to post a comment.
Can this be used as an external MAP sensor?
- We do not recommend this. To protect the sensor from vibration, you both solder its pins to a circuit board and bolt the pins to the same board. The pins are not intended to connect directly to a wiring harness.
What MegaSquirt units can I use this sensor with?
- This one works with V2.2, V3.0, and V3.57 main boards, as well as the DIYPNP. It does not fit the MSPNP Gen 2 or MSPNP Pro units, and we do not recommend it for systems with an external MAP sensor, as noted above.
Questions & Answers
- Q Can you tell me what vacuum hose size I need for this sensor? Might be useful information to incl... answer nowA
It is set up to use 1/8" hose.
- A
Please see the official data sheet for full specifications, including what pins are used for what purpose.
vitaliy
Hall Effect Crankshaft Position SensorI bought this item, it's not dirt cheap to me. But, I purchased it. Using it with ms2 extra. Had to do few steps, solder few wires to make it work. Instructions online available step by step. It was easy enough and the felling was rewarding that I did it. The sensor works beautifully, it does the job very nicely, so far I have no complains. Would say much sharper than the pickup sensor for sure. (Project: rotary engine Rx7) thanks diyautotune.
Bahaa Al Rayes
Excellent kit
Fast Shipping
Great support
kristanci roberto
The better solutionsRobert,from Italy,
This is the better ,cheapiest solution to drive a Classic europea 4 cylinder engine.
I install on Classic Opel,20xe,16 e .
Have about 20 cars runs MS 2, and some of that runs micro,the quickest solutions.
Thanks DIY,Good device,hope it test cheap!!!
Anthony
Well MadeA very clean installation - fit the v3.0 board perfectly. I won't go back to drilling and filing my own end plates.
Anthony
Huge Upgrade from MS1Very easy to swap out my MS1 processor for an MS2. Much faster and more functionality from 16x16 tables to stepper-style IAC to expanded trigger wheel options. Very happy.