Cart

Quick Links

DIYBOB Breakout Adapter - Nippon Denso 122 Pin

DIYBOB Breakout Adapter – Nippon Denso 122 Pin

4 out of 5 based on 1 customer rating
(1 customer review )

$104.00

In stock

SKU: DIYBOB-N122K Category: Brand:

Description

The DIYBOB is an exclusive breakout board from DIYAutoTune.com that allows you to easily build professional adapter harnesses connecting the engine management system of your choice to a wide variety of cars.  The DIYBOB includes an OEM style connector, circuit board, and an anodized aluminum case to finish it with a professional appearance. This one fits cars with a 122 pin Nippon Denso ECU as well as several ECUs with a lower pin count. See the DIYBOB main page for an application list. Use it to adapt a MegaSquirt, MicroSquirt, or any other ECU of your choice to the OEM wiring.

Customer reviews

Rated 4 out of 5 stars
1 review
5 stars 0 0 %
3 stars 0 0 %
2 stars 0 0 %
1 star 0 0 %

1 review for DIYBOB Breakout Adapter – Nippon Denso 122 Pin

  1. 5 out of 5

    Hall Effect Crankshaft Position SensorI bought this item, it's not dirt cheap to me. But, I purchased it. Using it with ms2 extra. Had to do few steps, solder few wires to make it work. Instructions online available step by step. It was easy enough and the felling was rewarding that I did it. The sensor works beautifully, it does the job very nicely, so far I have no complains. Would say much sharper than the pickup sensor for sure. (Project: rotary engine Rx7) thanks diyautotune.

    Was this review helpful to you? 0 of 0 people found this review helpful

  2. 5 out of 5

    Excellent kit
    Fast Shipping
    Great support

    Was this review helpful to you? 0 of 0 people found this review helpful

  3. 5 out of 5

    The better solutionsRobert,from Italy,
    This is the better ,cheapiest solution to drive a Classic europea 4 cylinder engine.
    I install on Classic Opel,20xe,16 e .
    Have about 20 cars runs MS 2, and some of that runs micro,the quickest solutions.
    Thanks DIY,Good device,hope it test cheap!!!

    Was this review helpful to you? 0 of 0 people found this review helpful

  4. 5 out of 5

    Well MadeA very clean installation - fit the v3.0 board perfectly. I won't go back to drilling and filing my own end plates.

    Was this review helpful to you? 0 of 0 people found this review helpful

  5. 5 out of 5

    Huge Upgrade from MS1Very easy to swap out my MS1 processor for an MS2. Much faster and more functionality from 16x16 tables to stepper-style IAC to expanded trigger wheel options. Very happy.

    Was this review helpful to you? 0 of 0 people found this review helpful

Add a review

What engine management systems can I use this with?

  • This breakout board is not specific to any particular engine management. You can use it with any ECU that is capable of running your engine and has the features you need.

How exactly do I connect my ECU to this one?

  • Start with a harness that has the ECU on one end and the other end unfinished. Run it in through the grommets on the back of the case, and then solder it to the main board.

Questions & Answers