Description
RacePak Vnet wiring uses a series of plug in extensions. This one has a male / female connector at one end and a female connector at the other, letting you add an extra module to your Vnet.
Related Products
IAC Valve Pigtail (6″)
$8.49IAC Pigtail (6") for Jeep Stepper Motor Idle Air ControllersThis is the wiring pigtail to compliment DarkStar's IAC Valve body complete with detailed assembly instructions (it's super easy- basically just plug them in) so that you can color code the w...
Add to cart
3/8″ NPT Stainless Steel Weld-On Bung for IAT or CLT Sensor
$9.493/8" NPT Stainless Steel Weld-On Bung for IAT or CLT SensorOur 3/8" pipe fitting for temperature sensors is now available in stainless steel. This one can be welded to either stainless or mild steel. Comes with galvanized steel plug as well.
Add to cart
IAC Valve Connector with Crimp Terminals
$6.99IAC Valve Connector (Uncrimped)Complete with the connector, four pins, plus an extra pin (just in case)
Add to cart
EGT Port Cap Kit – Package of 3
$11.49Removing your EGT probes? Seal the hole with these cap kits.Note: These will not fit our thread in fittings (EGT_0004). If using the thread in fittings, you will need to unscrew the fitting and replace with a 1/8" NPT pipe plug instead. They will fit ...
Add to cart
Mild Steel EGT Weld-In Compression Fitting
$12.00Weld this compression fitting into your headers or exhaust pipe. It holds a EGT probe securely in place. Compression type fitting provides a leak-free seal that holds up at high temperatures.
Add to cart
Open Tip EGT Probe Black Stinger
$73.00Measure your exhaust gas temperature per bank or per cylinder with this open tip EGT probe. It is a K type thermocouple with an 8 foot lead. The open tip EGT probe reads slightly faster than an enclosed tip probe, but tends to wear faster in extreme heat ...
Add to cart