$15.00
-
End cap to seal off your RacePak Vnet wiring harness.
There are no questions yet, be the first to ask something for this product.
DL32 Datalogger and Sensor Controller The DL-32 is a complete vehicle-mounted data-logging system for advanced engine tuning. The system is anchored by Innovate's award-winning digital wideband air/fuel ratio technology, but also includes flexible sens...
Add to cart
GM Closed Element Coolant / Oil Temperature Sensor with Pigtail Suitable for use as a Coolant Temperature Sensor (CLT) on all vehicles. This can be used as an Intake Air Temp Sensor (IAT) on naturally aspirated vehicles if there are severe vibration is...
Add to cart
Measure your exhaust gas temperature per bank or per cylinder with this open tip EGT probe. It is a K type thermocouple with an 8 foot lead. The open tip EGT probe reads slightly faster than an enclosed tip probe, but tends to wear faster in extreme heat ...
Add to cart
Bosch Style Fuel Injector Plug with 6" Wire Pigtail Fits a wide variety of cars that use Bosch injectors, including many Ford, GM, and BMW products. This connector also fits many Bosch temperature sensors. This connector incorporates seals on the pins ...
Add to cart
Attach an EGT probe to your exhaust without welding using this worm drive clamp and compression fitting. Fits 1.56" to 2.5" OD tube headers or exhaust pipes, with a 3/16" compression fitting for use with our EGT probes. Made from stainless steel.
Add to cart
Removing your EGT probes? Seal the hole with these cap kits. Note: These will not fit our thread in fittings (EGT_0004). If using the thread in fittings, you will need to unscrew the fitting and replace with a 1/8" NPT pipe plug instead. They will fit ...
Add to cart
Reviews
There are no reviews yet.