Description
12 pin connector with pre-crimped 8″ black wires. Included with MSPNP-MM9697 for extra inputs and outputs. Can also be used to repair factory wiring harnesses.
12 pin connector with pre-crimped 8″ black wires. Included with MSPNP-MM9697 for extra inputs and outputs. Can also be used to repair factory wiring harnesses.
Included is an 8' long harness for installing the MicroSquirt on larger vehicles instead of motorcycles and ATVs. Serial cable included.
Add to cartThis electronic boost control solenoid can be used with the MS3-Pro/MSPNP as well as any DIY Style MegaSquirt EMS (with the appropriate mods), or with other electronic boost controllers to control boost by adjusting the pressure to a turbo wastegate. Th...
Add to cartTPS-3 Connector (Uncrimped) GM Style 3-pin TPS Connector complete with: the 3-pin connector three pins plus an extra fourth pin (just in case)
Add to cartMany older tachometers trigger off the negative terminal of the ignition coil. Often, these use a filtering circuit which will not trigger when given a 0 to 12 volt square wave signal, such as the tach output signal from an ECU or ignition box. If you h...
Add to cartMegaSquirt Relay Board - Assembled Unit - Part# MSRelay-C Though the Relay/Power Board is not required, it is a convenience and can reduce the chance of miswiring during the installation. The relay board provides a central place for all of the required...
Add to cart
Reviews
There are no reviews yet.