Description
30″ Universal harness and serial cable for MicroSquirt (sold separately). This package includes all the wiring normally included with the Microsquirt on its own for customers who happen to need a spare or replacement harness.
MicroSquirt 30″ Pigtail Harness
$84.00
In stock
Customer reviews
2 reviews for MicroSquirt 30″ Pigtail Harness
Add a review
You must be logged in to post a comment.
Where is this harness manufactured?
- It is assembled in the USA.
What sort of serial cable does it use?
- It uses the same DB9 to 2.5 mm barrel connector used with the Innovate LC-1 and VVTuner.
What grade of wiring is used?
- This harness uses 20 gauge TXL high temperature automotive wiring. All wires are color coded and printed with their functions.
Where can I get a wiring diagram for it?
- See the documentation at MSExtra.com.
Can I remove any wires I’m not using?
- Yes. You can unlock the connector with a screwdriver, at which point unused wires simply pull out the back of the connector. If you need to maintain waterproofing, you will need to insert a cavity plug into the connector (not included).
Questions & Answers
- A
Yes - the main difference is the VR2 wiring is a little different. On a V3 MicroSquirt, the VR2 wire is a differential input; on the earlier ones, it's a sensor ground.
vitaliy
Hall Effect Crankshaft Position SensorI bought this item, it's not dirt cheap to me. But, I purchased it. Using it with ms2 extra. Had to do few steps, solder few wires to make it work. Instructions online available step by step. It was easy enough and the felling was rewarding that I did it. The sensor works beautifully, it does the job very nicely, so far I have no complains. Would say much sharper than the pickup sensor for sure. (Project: rotary engine Rx7) thanks diyautotune.
Bahaa Al Rayes
Excellent kit
Fast Shipping
Great support
kristanci roberto
The better solutionsRobert,from Italy,
This is the better ,cheapiest solution to drive a Classic europea 4 cylinder engine.
I install on Classic Opel,20xe,16 e .
Have about 20 cars runs MS 2, and some of that runs micro,the quickest solutions.
Thanks DIY,Good device,hope it test cheap!!!
Anthony
Well MadeA very clean installation - fit the v3.0 board perfectly. I won't go back to drilling and filing my own end plates.
Anthony
Huge Upgrade from MS1Very easy to swap out my MS1 processor for an MS2. Much faster and more functionality from 16x16 tables to stepper-style IAC to expanded trigger wheel options. Very happy.