Description
Included is the JimStim CPU. A microcontroller loaded with the latest code, currently V2.0.4.
Included is the JimStim CPU. A microcontroller loaded with the latest code, currently V2.0.4.
The JimStim CPU is not easy to test separately from the JimStim, but if the 3.3 volt supply is putting out the correct voltage, it should be safe to install a new processor. The most common cause I've seen of damaging the processor is if the JimStim is switched on while placed on a metal surface.
Google translation: Процессор JimStim нелегко тестировать отдельно от JimStim, но если источник питания напряжением 3,3 В подает правильное напряжение, он должен быть безопасным для установки нового процессора. Наиболее распространенной причиной, по которой я видел повреждение процессора, является то, что JimStim включен, когда он помещен на металлическую поверхность.
BA05CC0T 5 volt regulator, used as a higher capacity replacement for LM2937ET-5.0-ND. U5 in both the V2.2 and V3.0 kits.
Add to cartMegaSquirt-I CPU; Motorola 68HC908 microprocessor loaded with standard B&G MegaSquirt-I firmware version 3.0. This part is discontinued - sorry, we've sold out the whole stock. For use with any MegaSquirt PCB version 1, 2.2, 3.0, 3.57...
Read moreIXDI604PI dual inverting MOSFET driver. Replaces the IXDI404PI in the original bill of materials. This is U4 in a V3.0 board, U7 in a V2.2.
Add to cart10-pack of wire jumpers in 5 colors. These fit 0.1" headers and are used on the JimStim to make connections for testing additional circuitry. There are several other uses for them too.
Add to cart
Reviews
There are no reviews yet.