Cart

Quick Links

CPU - MegaSquirt-II Daughterboard

CPU – MegaSquirt-II Daughterboard

4.5714285714286 out of 5 based on 7 customer ratings
(7 customer reviews)

$136.00

-

Description

MegaSquirt-II Daughterboard

For upgrading your Megasquirt-I ECU, or replacement of your damaged MegaSquirt-II daughterboard.  MS2 daughter cards are for use only with genuine Bowling & Grippo MegaSquirt mainboard PCBs. This is the latest version of the MegaSquirt-II daughterboard with the C64 processor and is CAN-enabled. The latest embedded code can be found at the MS2/Extra downloads page.

Customer reviews

Rated 4.5714285714286 out of 5 stars
7 reviews

5 reviews with rating of 5 stars (5 of 7)

(Show unfiltered results)

7 reviews for CPU – MegaSquirt-II Daughterboard

Only logged in customers who have purchased this product may write a review.

What firmware is on this daughter card?

  • This processor ships without full firmware. It has the bootloader installed so you can easily load any MS2 code to it.

Can I order this pre-loaded with firmware?

  • We do not offer it with firmware as it is much easier to load firmware once this card is installed in a MegaSquirt ECU. Once you have it installed, you can easily load firmware using a laptop.

Questions & Answers

    Dose this work on ms1 2.2
  1. 0 votes
    Q Dose this work on ms1 2.2
    A

    You can install it as an upgrade, although the MS2 / V2.2 combination is not as well documented or up to date as the MS2 / V3.0 or MS2 / V3.57. See the MS2/Extra archive web manuals for notes about this combination.

  2. Will this fit both a PNPMS2 as well as the generic DIY MS2 kit?
  3. 0 votes
    Q Will this fit both a PNPMS2 as well as the generic DIY MS2 kit?
    Asked by Ray
    A

    The MSPNP Gen 2 is based on the MicroSquirt Module and does not use an MS2 daughterboard.

  4. Is the MS2 daughter board a kit, or assembled? And, is this MS2 extra? fuel and spark?
  5. 0 votes
    Q Is the MS2 daughter board a kit, or assembled? And, is this MS2 extra? fuel and spark?
    Asked by Mark
    A

    The daughter board is assembled and ready to drop onto a MegaSquirt main board. It ships without firmware but can be loaded with Bowling & Grippo code or MS2/Extra. Loading code can be done with an ordinary serial cable and a laptop, no special tools required, and takes about five minutes.

Only registered users are eligible to enter questions