Assembly Instructions for the IAC Pigtail 'Piggy'

Part# IACPiggy available here

I have packaged the wires and the connector dissembled because there are at least two configurations for the inline idle air control valve.  Click Here for the MS2 IAC documentation or Click Here for a quick reference image showing how to determine how to wire your IAC Valve.

Here is what comes with the kit.  The connector itself along with two blue wires and two green wires, with pins attached. 

Here is a picture of the orientation of the pins relative to the connector.  Basically you're going to first decide which way you want to color coordinate your wiring (depending on how you're going to wire your IAC) and then you'll simply push the pins into the back side of the connector.

After pushing the pin in the yellow seal might need some coaxing.  By pushing in and rotating at the same time it will go in.

Keep wiggling and bushing after you get past the first ring and it'll go in smoothly.

And the before(bottom) and after(top) shot:

Click Here if you have questions or would like to contact us!