MegaSquirtPNP Gen 2
Plug-N-Play Standalone Engine Management System
MegaSquirtPNP Model #T8590 Features
Fits several Toyota applications, all USDM with manual transmission:
- 1985-1987 Toyota Corolla AE86 with 4AGE
- 1985-1989 Toyota MR2 with 4AGE
- 1987-1989 Toyota Corolla FWD models with 4AGE
- 1985-1990 Toyota Pickup or 4Runner with 22RE
New second generation MSPNP!
We've totally redesigned the MSPNP! This new second generation unit runs MS2/Extra sequential code, using the MicroSquirt Module and a lot of new MSPNP-specific hardware. We've added several major improvements over the original. Here's the features of the new model.
Easy to Use and Install!
- Fully Plug and Play Installation - No wiring required for basic functionality. Average install time is under 1 hour!
- 4AGE base map is pre-loaded to help your engine start on the first turn of the key (other model base maps included on CD)
- Real time tuning and data logging with a laptop connection
- Supports most aftermarket wideband sensors
Fully Tunable Engine Control!
- 16x16 Fuel Tables allow high resolution tuning
- 12x12 Ignition Tables
- Multiple Acceleration enrichment strategies
- Closed Loop Idle Speed Control
- Air Conditioner Control
- Up to 4 sequential fuel injector channels with individual trim tables (minor wiring change required to run sequential, 4AGE only)
- Onboard peak and hold drivers support both high and low impedance injectors - No external ballast resistor is needed!
- Allows removal of stock airflow meter
Advanced Feature Set (Included!)
- 12x12 Air Fuel Ratio Target Tables for use with wide band O2 sensor for precise tuning and table trim.
- Built-in 2-step rev limiter / launch control with flat shift
- Real time barometric correction
- Internal 4-bar MAP sensor reads up to 44PSI of boost
- Overboost protection
- Closed loop boost control (Requires DIYAutoTune.com EBC solenoid kit)
- Knock sensor input with adjustable sensitivity
- Headphone output for knock sensor - listen for knock while you tune!
- Table switching input. Change fuel and spark maps on the fly for different fuels, nitrous activation, etc.
- Input for flex fuel sensor - switch between E85 and gasoline on the fly!
- CANBus connector allows interconnection of other MegaSquirt-compatible devices for additional functions (EGT Input, Automatic Transmission Controller, Additional Sensors.....the possibilities are limitless!
What you get in the box:
-
MegaSquirtPNP T8590 ECU
-
MSPNP Tuning Cable, 6'
-
Tuning Software and Documentation CD
-
6' Vacuum Hose for MAP Signal and 'T' fitting
-
Four Screws for ECU mounting
|
