MegaSquirtPNP Gen 2
Plug-N-Play Standalone Engine Management System
MegaSquirtPNP Model #NS8994 Features
1989-1994 Nissan 240SX KA24E or KA24DE w/ manual tranny
Also fits the following USDM applications (all with manual tranny):
- 1991-1994 Nissan Sentra / NX1600 / NX2000 with GA16DE or SR20DE
- 1991-1993 Infiniti G20 with SR20DE
- 1990-1995 D21 Hardbody pickup with KA24E
New second generation MSPNP!
We've totally redesigned the MSPNP! This new second generation unit runs MS2/Extra sequential code, using the MicroSquirt Module and a lot of new MSPNP-specific hardware. We've added several major improvements over the original. Here's the features of the new model.
Easy to Use and Install!
- Fully Plug and Play Installation - No wiring required for basic functionality. Average install time is under 1 hour!
- KA24 base maps is pre-loaded to help your engine start on the first turn of the key (other model base maps included on CD)
- Real time tuning and data logging with a laptop connection
- Supports most aftermarket wideband sensors
Fully Tunable Engine Control!
- 16x16 Fuel Tables allow high resolution tuning
- 12x12 Ignition Tables
- Multiple Acceleration enrichment strategies
- Closed Loop Idle Speed Control
- Air Conditioner Control
- Up to 4 sequential fuel injector channels with individual trim tables (optional trigger disc required for sequential injection)
- Onboard peak and hold drivers support both high and low impedance injectors - No external ballast resistor is needed!
- Allows removal of stock airflow meter
Advanced Feature Set (Included!)
- 12x12 Air Fuel Ratio Target Tables for use with wide band O2 sensor for precise tuning and table trim.
- Built-in 2-step rev limiter / launch control with flat shift
- Real time barometric correction
- Internal 4-bar MAP sensor reads up to 44PSI of boost
- Overboost protection
- Closed loop boost control (Requires DIYAutoTune.com EBC solenoid kit)
- Knock sensor input with adjustable sensitivity
- Headphone output for knock sensor - listen for knock while you tune!
- Table switching input. Change fuel and spark maps on the fly for different fuels, nitrous activation, etc.
- Input for flex fuel sensor - switch between E85 and gasoline on the fly!
- CANBus connector allows interconnection of other MegaSquirt-compatible devices for additional functions (EGT Input, Automatic Transmission Controller, Additional Sensors.....the possibilities are limitless!
Note: Many of these models do not have an IAT (Intake Air Temperature) sensor from the factory. On these cars, we strongly recommend installing a GM IAT to allow for air temperature correction.
What you get in the box:
-
MegaSquirtPNP NS8994 ECU
-
MSPNP Tuning Cable, 6'
-
Tuning Software and Documentation CD
-
6' Vacuum Hose for MAP Signal and 'T' fitting
-
Four Screws for ECU mounting
|
