Cart

Quick Links

DIYPNP Upgrade: Sequential Injection Kit
DIYPNP Upgrade: Sequential Injection Kit
DIYPNP Upgrade: Sequential Injection Kit
DIYPNP Upgrade: Sequential Injection Kit
DIYPNP Upgrade: Sequential Injection Kit

DIYPNP Upgrade: Sequential Injection Kit

5 out of 5 based on 1 customer rating
(1 customer review)

$43.99

-

SKU: DP_SEQMOD-K Category: Brand:

Description

Add two extra injector drivers to your DIYPNP with this new module and the latest MS2/Extra code! We’ve partnered with JBPerf to develop this tiny module with two extra injector drivers. Allows for fully sequential injection on a 4 cylinder engine, semi-sequential on a 6 or 8 cylinder. Installs with a 10 pin shrouded header, included with the kit.

Click HERE for full DIYPNP Sequential Module Installation and Configuration Documentation.

Note: This is not intended for regular MS2s or standard MicroSquirts, only DIYPNPs and other devices built around the MicroSquirt Module.

Customer reviews

Rated 5 out of 5 stars
1 review
4 stars 0 0 %
3 stars 0 0 %
2 stars 0 0 %
1 star 0 0 %

1 review for DIYPNP Upgrade: Sequential Injection Kit

Only logged in customers who have purchased this product may write a review.

Can this be used with a regular MS2 or MicroSquirt?

  • It is only intended for use with MicroSquirt Module based devices like the DIYPNP.

Questions & Answers

    The IAC pin and 12v pin will function through the board???
  1. 0 votes
    Q The IAC pin and 12v pin will function through the board???
    Asked by luis baez
    A

    Yes, it does not interfere with these connections.

  2. Can the adapter board run low impedance injectors?
  3. 0 votes
    Q Can the adapter board run low impedance injectors?
    Asked by Mark
    A

    These drivers are intended for saturated (high impedance) injectors. Running low impedance injectors using this board without current limiting resistors may send the drivers into overcurrent protection or overheat the injectors.

  4. how to wire it up on microsquirt module? since i'm build an ECU without MSPNP package
  5. 0 votes
    Q how to wire it up on microsquirt module? since i'm build an ECU without MSPNP package
    Asked by Nandosuke
    A

    The pinout follows the above picture of the DIYPNP. The points you will need to connect are the two ground holes (green) to power ground, and connect PT6 and PT7 to the holes marked in red.

Only registered users are eligible to enter questions